| Forum: LAB Lounge |
|---|
| Topic: What's the "Audix OM7" of drum mics? |
|---|
| Re: What's the "Audix OM7" of drum mics? [message #352879 is a reply to message #352856 ] |
Wed, 20 August 2008 00:30 |
 |
 Robert Lunceford
Messages: 248
Registered: April 2004 |
Has No Life |
|
|
Hey Evan, That is a much better clip. It didn't occur to me that the first video was shot with a cell phone.
I really liked the "poppin'" sound clip you posted on your website - great job.
Are you traveling to England with the band?
Robert
|
|
|
| Topic: Bass in Mids |
|---|
| Re: Bass in Mids [message #352880 is a reply to message #352731 ] |
Wed, 20 August 2008 01:01 |
|
If u use 3 way setting,it must have been Hi-Mid-Subwoofer setting....and it is more difficult to you if you setting use analog xover than LMS that we can see and adjust freq and slope for each output of driver.Except u use the controller for that speaker ( Like Martin Audio EM76 use ICT controller from martin, we dont need to setting too much, cause the sound will hears perfectly)
if u use the analog xover from different brand from speaker and subwoofer,that you can try adjust manual with this way :
when all the setting is on : play sound with familiar cd that u ussualy use and try for high freq, turn down volume for MID and LOW (SUB) in xover/power until you just hear the HIGH freq from the speaker and find the freq from xover freq until no mid freq hear or just a little (around 1,7khz, and for MID do the samething until no high freq and low freq hearing, just mid !
and do the samething for thesubwoofer, find about in 80-120 hz for the sub, but sometimes you must make it about up to 100hz to make it punch,(it my suggest and depend for your taste)
it depend from your each driver from speaker too (is it in perfect condition or not) and dont forget to check the phase from each driver (hi-Mid-Low) for sub its more easy to see (they go out when we play loud freq) but sometimes like JBL they go IN for the SUB for right phase.
I hope this can help u to setting and make nice sound!
good luck
Novin Tjiandra
FOH Engineer & System Engineer
LPM Inc.
Supplier & Rental
Soundsystem,Lighting Show & Musical Equipment
www.saudiosound.com
|
|
|
| Topic: Computer through PA - poor sound quality - advice? |
|---|
| Re: Computer through PA - poor sound quality - advice? [message #352885 is a reply to message #352354 ] |
Wed, 20 August 2008 01:15 |
|
You need to check :
1. your soundcard use Mono or stereo output!!
2. check your volume level in notebook, ( about half or 3/4) in volume master in windows, flat eq and no effect if any) and boost the volume from your mixer, cause if from the source it overload or peak in your mixer the sound will not hear good how good you set it
3. Check your cabling from notebook to Line input ( check the wire and + independent and - and earth you join together) or use each pin when u use stereo jack.
4. use pad if your mixer have it, to reduce the signal and boost it from gain.
5.the last from the source you play. try to play cd music from your notebook's cd room and hear the sound and play the source you want to play ( like mp3/mp4/Mpg ) if the sounds very different from cd its cause from the source and your system dont wrong anything at all.
use connection from sound card notebook to line input mixer always do the same way, and the sounds so perfect, it depends from your cabling and the source what we want play.
good luck
Novin Tjiandra
FOH Engineer & System Engineer
LPM Inc.
Supplier & Rental
Soundsystem,Lighting Show & Musical Equipment
www.saudiosound.com
|
|
|
| Topic: Powered Speaker Dilemma - Thoughts |
|---|
| Re: Powered Speaker Dilemma - Thoughts [message #352884 is a reply to message #352870 ] |
Wed, 20 August 2008 01:14 |
Chris Poole
Messages: 26
Registered: December 2007
Location: Toronto, Ontario |
Should Get Out More |
|
|
I can vouch for the NX750Ps getting quite loud, and having acceptable sound quality.
I have only used them in a monitor role, but in that application they excelled. I was able to run kick and bass guitars through them (in addition to vocals) and achieve very good results, at very high SPL. I have even had screamo-type bands ask me to turn their vocals down in their mix when using the 750's as wedges.
Some things to keep in mind:
They are relatively large enclosures (38D x 56W x 84H cm)
Heavier than many powered 12"s tend to be (27.3kg)
They have 80x50 HF dispersion, which is good for wedges, but which might be a little awkward in practice for FOH enclosures. I would find 80degrees to be too narrow for good coverage of many rooms singly, yet a bit too wide to really array well (speculation on my part -again, I've only used them as floor monitors.)
[Updated on: Wed, 20 August 2008 01:15]
|
|
|
| Re: Powered Speaker Dilemma - Thoughts [message #352888 is a reply to message #352884 ] |
Wed, 20 August 2008 01:31 |
Bob Kenton
Messages: 418
Registered: May 2005
Location: Sandy beaches of OC |
Has No Life |
|
|
|
Not a bad start. I like the HPR122's, great price, sound great, do well as mains and monitors. If the need ever comes, you can rent a powered sub until the time comes to buy one.
|
|
|
| Topic: 4 Amps the choose from. |
|---|
| Re: 4 Amps the choose from. [message #352889 is a reply to message #352777 ] |
Wed, 20 August 2008 01:49 |
Dave Potter
Messages: 210
Registered: April 2004
Location: North London |
Has No Life |
|
|
Hi Rob,
The MOSFET1000 has a lot less gain, due to the fact that the input isn't ballanced. it was an optional extra. However, I couldn't find the right sound by adjusting the gain.
*************************************************
"When he wakes up, think of something cool. Tell him I said it" ( Buffy)
www.davethebass.com
www.myspace.com/theswatbanduk
|
|
|
| Forum: The Basement |
|---|
| Topic: amusing soundman webcomic |
|---|
|
| Topic: A Barking Dog named Dave retires the blog |
|---|
| A Barking Dog named Dave retires the blog [message #352883] |
Wed, 20 August 2008 01:14 |
Steve Weiss
Messages: 406
Registered: July 2004
Location: Las Vegas |
Has No Life |
|
|
http://rex.roaddog.com/mt/blog/
Dave writes the truth. I am sad to see it end.
|
|
|
| Topic: Where emo actually comes from... |
|---|
| Re: Where emo actually comes from... [message #352886 is a reply to message #352783 ] |
Wed, 20 August 2008 01:17 |
Woody Nuss
Messages: 158
Registered: April 2004
Location: los angeles |
Has No Life |
|
|
I expected to see this:
|
|
|
| Topic: LeRoi Moore |
|---|
| Re: LeRoi Moore [message #352890 is a reply to message #352823 ] |
Wed, 20 August 2008 02:00 |
|
I got the news about this tonight while I was mixing a show...and I still can't wrap my head around it. I have admittedly been a huge DMB fan since their very very early days, but LeRoi has always been my favorite. Even growing up as a drummer and trying to learn EVERY drum groove off of their albums, it was always LeRoi's sax playing that drew me into the music.
We have lost a ridiculous number of GREAT people this past month, but this one really stings for me. The highlight of their live shows for me was always LeRoi playing the meanest Bari Sax ever....no one can get that funky on a Bari!
Steve Milner
Steve@stevemilner.com
www.stevemilner.com
|
|
|
| Topic: Audio antics - post your pics here! |
|---|
|
|
| Forum: LAB: The Classic Live Audio Board |
|---|
| Topic: It's days like this... |
|---|
| Re: It's days like this... [message #352876 is a reply to message #352330 ] |
Wed, 20 August 2008 00:08 |
sndguy (Joel Ashcraft)
Messages: 44
Registered: April 2004
Location: FL |
Should Get Out More |
|
|
??
There was no audience anywhere on the field. They were in the stands, so we opted to not layout 40 cable ramps.
|
|
|
| Topic: WIRED Mag Wants YOUR opinion on RF Whitespaces |
|---|
|
| Topic: QSC PLX OUTPUT |
|---|
| QSC PLX OUTPUT [message #352882] |
Wed, 20 August 2008 01:12 |
|
Robert Lunceford
Messages: 248
Registered: April 2004 |
Has No Life |
|
|
QSC PLX3402
700wpc @ 8 ohm load
1100 wpc @ 4 ohm load
What would the ouput rating on this amplifier be at a 2.66 ohm load?
How about the current draw at 1/8th power?
|
|
|
| Topic: IEM Suggestions |
|---|
| Re: IEM Suggestions [message #352887 is a reply to message #352868 ] |
Wed, 20 August 2008 01:28 |
Kevin Hu
Messages: 11
Registered: August 2006 |
Here Often |
|
|
|
Another vote here for the Sennheiser packs. For me its a no-brainer on the senns. I've used the PSM700 and 600's in the past and have had nothing but bad experiences w/ RF interferences (with those systems) cutting in and out, even with the use of shark-fin directional antennas in the mix to provide perfect "RF line of sight" so to speak. When I've used the senns. I've never encountered the issue and even if I did I have the great ease of having the receiver scan for open frequencies, which is a one up from the Shure's. Aside from killer performance, the senns. body back is like half the size of the Shure's, which is an added perk as well.
|
|
|
Forum Home
Login
Forum Search
Register
FAQ
